Parameter Backup

[cncboy1]

Hallo

How can i make a parameter backup on a OSP5000L and OSP7000L controler to a (CN0) RS232 port?
On a M-controler is it easy, they have transmit softkey.

rg

[Algirdas]

yes, it's quite different for lathe. There is softkey also. You need to find it with "extend" (F8).
Take care about parameters - these differs for parameter save/ read from part program save/read.
On Edit mode You can try
=DPIP<write>
DPIP>OP CN0:IT
and <write> <write>
That's for lathe
here "IT" is file name. Extension will be .TOP