| | |
After a parameter restore on an OSP 700M Okuma mill, the feedrates on the jog feedrate selector switch are all crazy. Is there any parameter to correct this?
There is not a parameter that I'm aware of...was the reason for the restore that you reloaded or updated the software? If yes, I think you need to have it redone and corrected.
If not, then can you be more specific as to what exactly happens with the switch?
Yes, I installed a new memory card and reinstalled the software. Afterwards, I restored the parameters.
If you have the old memory card, power off, put it back in and see if when you boot with the old software your switch works correctly. If it does, you've got a software issue.
If the reason you replaced the memory card is that it doesn't work, check to see if there is more than one version of software in the back of your machine and try to load a different version onto the new card to see if it works.
By the way...which Jog key is giving you fits and what exactly is it doing?
I don't think it's a parameter setting - never heard of one for what you describe...
The manual feed job button
Posting Permissions
| | |
LinkBack URL
About LinkBacks
