where do I find hours?

[Hash01]

Does anyone know where I can find the actual spindle hours on an OSP7000L. I was just looking to find out what the total was on this LT10M is that I have been running.

[Superman]

Some earier machines have a physical counter or two at or near the main machine switch ( one that you can reset for part run time )

others have it in the "check data" or "Parameters" section ( near the back end of these areas ) and usually reports a minimum of:-
- Machine ON time
- Spindle run time
- Cutting time
---- individual part times are usually handled thru the MacMan or graphics pages

later controls P100 + also incorporate alarms for spindle bearing service timers and so on

[SE_Okuma_tech]

all the hours are kept under Macman with out standing there I cannot tell you which function key it is but check in macman and you will find it under reports