Multus - Calling in previous tool before a restart - CNCzone.com-The Largest Machinist Community on the net!

j44snk · #1 04-18-2009, 07:16 PM

Hi,

Does everyone have to do the above?
i.e. just ran T1 then T2 & I now want to run T2 again,normally I would load in T1 in MDI then do a restart for NA002(T2) - Time consuming!!!!!!!!!
If not, what do you do instead - does the OCHG macro eliminate this?

I don't know if anyone is interested but I have written a macro so you don't have to call in the previous tool when you do a restart, you can have any tool in the spindle & just restart for any Tool Number!!!!

Jason

Algirdas · #2 04-19-2009, 03:50 PM

just a second. Do You mean, that Okuma part program restart feature doesn't works at this case?

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Set up time on a Multus??	j44snk	Okuma	23	03-12-2009 01:28 PM
Need Help!- Each pass different than the previous	gage1049	DIY-CNC Router Table Machines	4	10-22-2008 04:47 AM
should we by a multus????	kennyayr	Okuma	1	08-20-2008 01:33 AM
Calling a Tool up	MBG	G-Code Programing	10	04-29-2008 10:04 PM
g code for repeat the previous move	woffler	G-Code Programing	6	03-26-2008 11:07 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)