OKUMA LB15 "ALARM 206 A Shear Pin 4"

[RISNA]

Hello all people,

I have purchased a Old Okuma LB 15 twin turret turning machine.
When I have powered on theis machine, There is alarm appeared on screen " ALARM 206 A Shear pin 4"
I have checked the alram list in the machine manuls, but there is no 200 series alarms in those manuls.

Does any body know what type of alarm is this? and how can i get rid of that?

Please help me.

regards.

Risna

Similar Threads:

• alarm 408 servo alarm "serial not RDY", αP18 fanuc mtor code
• Problem- X Axis "Goes Off Pattern", "Awry", "Skewed", "Travels"
• Need Help!- OKUMA LB15-II MW LATHE Alarm
• Hydraulic Shear "PROMECAM"
• LB15 set AutoCoolant "ON"???

[beartrax]

Our book says "The shear pin between the brushless motor and the ball screw is broken." Probably on the XA. The book says replace the pin.

[philserveng]

yes it could be the shear pin, but it may also be a bad shear pin monitoring switch.

[epeper]

The shear pin holds the 2 pullys by the x axis motor you need to see if its broken you will need a special nut to get the taper lock off if needed look in the parts book it will show u the shear pin,

[RISNA]

Thanks all,
I have got those shear pins. yes pins were broken.
l have replaced those pins and the alarm was gone.

But now machine is moving its all axes only in "MANUAL" mode. When I have pressed any other mode button, there is an Alarm" 124 Storke end limit cancel" appeared on screen.

The operating and Maintenance manual says "Operation other than Manual is selected while the storke end limit cancel switch is ON"

Where is the loction of this switch?

Please help me

Regards.

Risna

[Oti]

Usually inside the electrical panel.

[epeper]

Depending on the control its in the back in the elec cabinet a toggell switch that says o/t realese

[RISNA]

Thanks all, you are the great People.

And also the CNCZONE by which I will remain intuch with you.

Yes I got that switch in the electric panel at back side of machine.

I can not explain in words that how much you all are helpful to me.

This machine was not in working from last two months. Now it is in working.Oh!!!!!! thanks God.

Thanks and Regards.

Risna