Need Help!- Okuma Cadet Graphing

[Kart 34]

We have a Okuma Cadet turning center with a 5240 control on it.
I can not get the graph to put the material in the graph.
I was told to try putting

Clear
def Work
PS LC,[0,0],[1.25,2.0]
END
DRAW

In the beginning of my program and I would get a bar showing up in the
graph screen with a size of 1.25 dia by 2 inches long . This did not work.

Is there some where else to define the material stock on the control.
Is there a parameter I need to set???

Any help here

[bradleyk]

Not sure about the 5240 control.
Here's how I do it on my 5000L-G and 5020L controls. Length is first then diameter. For 2 inch long part by 1.25 inch diameter it would look like this:

DEF WORK
PS LC,[0,0],[20,12]
END
DRAW

Notice no decimals in the brackets. I don't know if the 5240 control works with decimals. Obviously the 12 isn't exact for 1.25 inch...it's up to you to use either 12 or 13 (1.2 or 1.3 inch).

[Kart 34]

Worked !!! Decimals seemed to be the problem.

Thanks Ron