| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Okuma Discuss Okuma machines here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-06-2007, 11:35 AM
| |||
| |||
| Need Pal for LSN-10 with AB 9-240 control I Have a Okuma LSN-10 with an Allen Bradley 9-240 control. New about 1990. I have been told some company was buying Okuma lathes new and putting different controls on them. They are out of business. I was given this lathe, because the battery went dead and the PAL ladder logic went away. I got the right AB software "ODS" off ebay, studied and wrote a very rudimentary ladder for this lathe. Got it minimally running, without the tool turrets working. I sure would like to find someone that has one of these lathes with this control and copy it's ladder logic. I would travel anywhere in the USA to download this ladder logic, if necessary. Thanks, Larry Reiss Omaha, Nebraska reiss_machinist at yahoo dot com four zero two two one eight three two eight eight    |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need to replace Dynapath 20 control with new control | Cycle Start | Knee Vertical Mills | 3 | 08-08-2010 04:14 PM |
| Using Flashcut CNC Spindle rotate card control to control laser power | pyroplotter | FlashCut CNC | 0 | 10-15-2007 10:46 PM |
| Torch Height Control / Capacitive Height Control | ahlbebuck | Open Source Controller Boards | 0 | 11-27-2006 02:32 PM |
| BobCADCAM Layer Control / Snap Control | jonbanquer | BobCad-Cam | 0 | 01-21-2006 04:10 PM |
| Change - from linear path control to CNC path control | fidibus42 | General Electronics Discussion | 1 | 12-04-2005 11:43 AM |
| | |
Linear Mode
