Okuma OSP-10UL Macro - CNCzone.com-The Largest Machinist Community on the net!

hense · #1 10-22-2007, 09:25 AM

Is there any equivalent command of DPRNT command in Okuma?

nma98ceg · #2 10-22-2007, 03:07 PM

I think so. Check the User Task chapter in the Programming Manual.

hense · #3 10-23-2007, 09:50 AM

I do not have the manual right now. Can anyone help me?

dcoupar · #4 10-23-2007, 10:59 AM

Here's the section from the manual. Looks like READ/WRITE should work.

hense · #5 11-05-2007, 05:00 AM

Hello Mr. Dcoupar. Thanks for the help. It worked well.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Okuma RS-232	dmealer	Okuma	18	09-06-2009 04:52 AM
okuma vs yci	pp-TG	General Metal Working Machines	0	10-02-2007 02:58 PM
Okuma - Helical macro	LeonH	G-Code Programing	9	02-27-2007 06:41 PM
Okuma igf	brtlatjgt	Machine Problems, Solutions , Wireless DNC, serial port	1	02-25-2007 07:34 PM
Okuma and pro cam	NCcustom	Suggestions for the CNCzone.com site.	1	12-29-2004 10:27 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)