okuma osp500l-g with sub-spindle - CNCzone.com-The Largest Machinist Community on the net!

pp-TG · #1 06-15-2007, 06:19 PM

Anyone know who to turn on the sub-spindle and sync. it to the front spindle in order to turn a part held in both spindles any help would be greatly appreciated..

Thanks, Travis

CCMAINE · #2 08-30-2007, 09:54 AM

N60 (t3 Part With Sub-spindle Pick-off)
G97 S2500 M3
G141
G50 S4200
M185
G97 S2600 M4
G140
G0 T0303 X25. Z-1.700 M8
M151
G0 W0
G1 W-.53 F.005
M248
G0 X1.5
G1 X-.01 F.002
G0 W0
G0 X25.
W25. M150
Z25. M05
G141
G0 X25. Z25.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Okuma RS-232	dmealer	Okuma	18	09-06-2009 04:52 AM
Okuma igf	brtlatjgt	Machine Problems, Solutions , Wireless DNC, serial port	1	02-25-2007 07:34 PM
Okuma Vmc ,g80 Turns Spindle Off	qmas99	G-Code Programing	7	05-20-2006 08:34 AM
Programming Okuma LT300 with Sub Spindle	SIMONB	General CNC (Mill and Lathe) Control Software (NC)	2	05-17-2005 10:44 AM
Okuma and pro cam	NCcustom	Suggestions for the CNCzone.com site.	1	12-29-2004 10:27 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)