The Okuma IGF can do that for you without manual coding I believe. It's in with cutoff if I remember correctly.
I am on a Spaceturn 3000EX ***OSP 200 Control***with subspindle and 1 turret (A and B sides) and need help with fat fingering a couple manual programs to insert in IGF program
I am needing to do:
A pick off with the sub spindle
A pick off with a part off with sub spindle with spindle sync
A pick off with part off with sub spindle then return sub spindle home for continue machining op on sub spindle
Any help would be greatly appreciated
Similar Threads:
- Need Help!- Steps to develop VB program to read CNC (G-code) program.
- Moving on.... 2010 CNC/manul Patriot on the block.
- Program recomendations for fanuc drip feed/program input/output
- Need Help!- Troubel looping a program in a 5 axis lathe program (sub spindle won't line up)
- Outputting Common variable values into a program (with automated program number)
The Okuma IGF can do that for you without manual coding I believe. It's in with cutoff if I remember correctly.
Experience is what you get just after you needed it.
I'll check it out...I don't remember it being a option but that doesn't mean it isn't there...thanks
This is for a part pick off with not cutoff withs spindle sync and torque skip
N100
(BLOW OUT SUB )
(TRANSFER**********************)
G97 S500
G50 S2000
G141
G50 S2000
G140
G97 S500 M03
M247
M249
M185
M151
G0W1.5
G29PW=35
G94 G22W-1.25D2.75L.25F100.PW=25
G29PW=11
M248
M246
G4F1.
M84
G4F1.
G28
G0W200.
M05
M150
G20HP=4
M1
thanks
no problem