MIN files are text files.
IGF filetype isn't text file, it is binary.
Dear colleagues.
,
First of all I am new on this forum and would like to say hello to the comunity.
I am writing here due to the little annoying problem I have when perform transmision between NC and PC. All is working well when transfer .MIN files but when try to send .IGF then immediatelly error showsup:
2556 ERROR sequential attribute 5
I have readad this error description in the manual, but to be honest it doesn't say a lot to me. Probably I am doing it wrong trying to transfer it using a PIP methode.
If anyone can help me with that and sugest what should I do to be able to transfer those files, that willbe very appreciated.
Best regards
Similar Threads:
MIN files are text files.
IGF filetype isn't text file, it is binary.
https://www.facebook.com/okuma.tuning
try floppy diskette
https://www.facebook.com/okuma.tuning
Well,
kurmay thanks for your advice. I have read other threads on this forum and as far as I can see only way to make backup copies of the programs from this machine, is to buy floppy-usb adapter/emulator.
but I also seen that some of them doesn't work and some does.
I've had decent luck with them, but...if your machine did not come with a built in floppy, and most 5020L controllers did not, you would also need the floppy interface board and cable set. It would honestly be cheaper to buy a real cam system than that board.
Sent from my SM-T813 using Tapatalk
If I recall correctly, the old OSP 5000 series controllers did not support transmission of the IGF files by way of RS232. If the machine came with the floppy interface then it might be possible but otherwise not.