Gotek floppy to USB emulator not working

[myhäje]

Many people seem to use these emulators with great success, however, I haven't had much luck so far.

The machine is a MX-45VBE with U-10M. The emulator powers on, I am able to format the USB stick using the emulator and I can even ready very small files from the USB stick using the control's MS-DOS interface. However, anything larger than a few hundred bytes and I get the error "333 floppy disk seek ERROR". After that the emulator ceases to work, any attempt to access FD0: results in "334 floppy disk recalibrate ERROR" message. It gets back to normal after restarting the control.

It would really suck to go back to using floppies so any advice is welcome!!

Similar Threads:

• floppy to usb emulator help please
• Floppy Emulator
• gotek floppy emulator in meldas 520
• Anyone using a USB / Floppy emulator?

[deadlykitten]

maybe this one ? Floppy Drive to USB Converter for Okuma Lathe + free 4 GB Flash Drive | eBay

[myhäje]

Not going to give up yet! (another emulator = another 2-3 weeks wait)

[deadlykitten]

you may consider another even if you would have no problems

[myhäje]

http://www.cnczone.com/forums/okuma/...version-2.html

if control unit is OSP7000 , you must use 4 jumpers on MO,S1,JA and JB
if unit is U100, 2 jumpers on MO and JA

THIS SAVED MY DAY!! Shorting MO and JA did it. I would have never guessed. This place ROCKS
Deadlykitten, you are correct, but I already bought two of these drives in case one of them goes boom

[deadlykitten]

osp7000, jumpers, input, data spec : this is out of my vocabulary mihaje, it was not me, but Kurmay the one who saved your day ! please take a look into that thread at post 16

i only tried to highlight information for you, from the right thread and i was tring sugesting to always consider alternatives even if things work ...

ps : still, if you have a spare lamborghini ....