Hello,
I have the CNC machine OKUMA OSP5000M-G MC-4VB.
I can not install software for the CNC machine because it alarm double memory
Do you have the software and floppy disk ?
Please help me.
My email : kntran77@yahoo.com
Do you mean bubble memory alarm? If that the case, you might as well retrofit or toss the machine. 2500+ for the new ram board, 3500+ for the software, and whatever your local dealer charges to come out with software and load it. Software is machine specific, and that old of a machine would have been on 8" floppy I'm sure.
Hello,
Thank you very much for reply
I buy old the board and replace it.
But now I need software and 8" floppy.
Can you sell for me price cheap?
Thank you.
Khoa Tran
Hello,
I have not tape transfer and I don't know it. I can only transfer G code the program from PC to OSP by RS232.
Can you help me the software installation from PC to OSP?
Thank you.
Last edited by KHOATRANNGOC; 07-20-2014 at 09:37 PM.
Ok, this sounds strange... but I have some NC-code files generated
by MetaCam but I don't have the PNG or DXF files they were generated from.
Is there a way to generate something like a source DXF
from them that makes sense for modifying the designs?