Hi all, We recently purchased a used okuma lr15 with osp 5020 control.
If I try to turn the spindle in mdi, I get a chuck open 1 alarm and the top Turret (A) starts to fall.
Then when I press reset to clear the alarm, another alarm dif over appears.
I gather this second alarm is because of the turret falling, so my questions are:
1. Why am I getting the original chuck open error.
2. Why does the turret fall after and alarm appears.
Also, does anyone have a training or programming manual for this machine for sale.
Thanx
David
managed to fix the chuck open alarm.....
The switch at the rear of the spindle was not set at the proper position...
Turret A still falls when power is deactivated eg. (emergancy stop is pressed)
Any OSP5000L to OSP7000L programming manuals should be OK, the info seems to be generic for the lathes, so if you have another Okuma lathe with manuals, these would get you going
If you have "One TOUCH" IGF , likewise, any manual would fill the gap
Machine specific manuals would obviously be parts, operation, installation and any attached units ( conveyor, c-axis etc ). The machine should have had them, last owner ( any chance, seeing he doesn't have the machine anymore ) ?? Okuma $$$,
someone may have these manuals on a CD and can copy it for a "tiny" fee
any takers???
Yes that would do...
I have operation and maintenance manual,s which should help me sort the problems Im having.
( With the help of this forum of coarse)
But the basic okuma programming and igf operations manuals would be a great help once the machine is fully operational.
I looked for the manuals for my LR-15 it has the 5020 too but I need the diagrams, parts manual and the operation manual. I too didn't get much with the lathe.
The door close doesn't seem to work and the old pattlite doesn't work either even with a new bulb.