Okuma OSP 5020L

[BrianM03]

I am looking for a program restart M code. It is M99 on a fanuc. I cannot seem to find it in book. Thank you in advance.

[fordav11]

M99 on Fanuc is 'End of sub program, return to main program'

To restart Okuma press soft button RESTART, type N number where you want to start and then press SEQUENCE RESTART hard button.

[Thawk53]

Brian,
I'm assuming you are wanting to run continuous?

N10 (RGH TURN)
G50S1500
G0G95G97X30.Z30.S375T0101M42M3M8
program
program
program
yada
yada
yada
/ GOTO N10
M30
%

[underthetire]

correct, Okuma uses more of a basic approach.
Same program with a part count. V1 on the variable display page will show part count.
N1 V1=0 (RE SET PART COUNT TO 0)
N10 (RGH TURN)
G50S1500
G0G95G97X30.Z30.S375T0101M42M3M8
program
program
program
yada
yada
yada
V1=V1+1
IF [V1 LE xxx] N10
M30
%

( LT=less than, LE less than or equal to, GT greater than, GE greater than or equal to, EQ equal to. There are more, these are the most used ones.)

[BrianM03]

Thank you very much. I was wondering if it had variables as well. I will dig deeper. This gets me through a crunch. Any ideas where to learn a bit of this? I am pretty good with the Fanucs, but lousy here. I live far outside of any metropolitan areas.

Brian

[underthetire]

Okumas had variable since before they had CRT's

You can assign pretty much anything as a local variable. Then you have the V variables, and system variables for tool offsets, chuck functions, on and on.

Local variable program...

G50 S3500
M42
S100M3
RPM=100
NSTART
S=RPM
RPM=RPM+1
IF[RPM LT 3500]NSTRT
M30

I dont have a way to test this, but I think it's correct. Makes "RPM" a local variable. This just runs the spindle up to 3500 for a warm up.

[Algirdas]

there is also schedule program in OSP. You can learn from any Okuma programming manual, differences are minor