| | |
I have a little lb9, has a 25 pin male hookup, wishing to get it talking to my PC. I have found parameter settings online but always for the OSP5000 control, and it always call for parameter settings for some that I dont have. Anybody got a comm. setup sheet for this little lathe? Everything I have tried has been for naught.
The first step it is cable.Originally Posted by spock
Ocuma not support RTS/CTS and DSR/DTR hardware protocol.
You NEED do connect each other some pins in cable itself:
DB9 side
4 and 6 (DSR/DTR)
7 and 8 (RTS/CTS)
DB25 side
4 and 5 (RTS/CTS)
6 and 20 (DSR/DTR)
And only after this, all your setting will work.
Untill I changed the cable no sending/receiving were.
a little correction. Okuma OSP supports hardware hand-shaking protocols on default RS-232 port and on drip-feed port absolutely.
The cable connection without hardware handshaking is good because it's much easier to set serial connection that way.
You should also have the same parameters as a 5000lg or a 5020lg control. The 500 was just a smaller screen and keyboard on a lb9.
I will have to do some more checking on the machine tomorrow, but I know that par. settings that I downloaded for the 5000L had changes to word parameter #54, I think my machine stopped in the 40's. It only takes one to be wrong for it not to work....
A 5000l is different, much older. You need a 5020l or 5000lg
Posting Permissions
| | |
LinkBack URL
About LinkBacks
