Tailstock Spindle Condition Illegal Alarm1717

[dingo0722]

I want to leave center work activated but when I command the spindle I get the 1717 alarm. I have tried using M157/156 but it has no affect This is on an OSP10UL Crown Lathe

[Algirdas]

"Tailstock interlock release" code must work. Quill must be retracted.

[dingo0722]

ok we got it to work. It was a programming error when entering the m code into the MDI. M157-write-cycle start S100M03-write-cycle start. We were not pressing cycle start after each block.

[Cncaron]

Try using an m157 m167 together
For this interlock override should fix the problem