Okuma Lathe LU15/OSP-U100L

[edirig1]

I am interested in getting some cycle boring help. I want to remove a lot of stock from the I.D. of a piece of stock aluminum. This would be a good example of a fixed can cycle but I have never done one before and need some help. Any advice would be appreciated. Thanks.

Also can this be done with constant surface speed?

edirig1

[littlerob]

CNCzone.com-The Largest Machinist Community on the net! - Search Forums

A few search words; Canned cycle, G85, Lap, uhh Newbie

http://www.cnczone.com/forums/g-code_programing/

Here will help with basic G-code as well