OKK 860 MELDAS 530 CONTROL

[shredder]

Hi guys I have a okk860 with a meldas 530 control, its a great machine but when I cut a 3-d profile it jerks and stutters and almost completly stops when going over a rad, g5 p1 does not seem to do anything,I have tried changing several parameters with no luck.
Any suggestions ?
thanks

[girishdk]

1) Check Control Parameter #34 Initial G61.1 is ON
2) Check any PLC-SW "Error Detect" is ON.

Believe you already tried the Parameters, Option Installation may be required

[OKK Rey]

Not sure if your machine has the HPCC option installed or not. If you send me a message with your serial number or MA# I can help you get on the right track.

-Rey Borges
OKK USA Corporation