Need Help! Meldas 500 Series - CNCzone.com-The Largest Machinist Community on the net!

ScoobyDoo · #1 10-02-2009, 09:48 PM

Anyone know what the steps/settings are to set an M530MH controller so it's ready to receive data from a laptop to trickle feed??? The machine in an OKK KCH 500.

Thanks!!

onthebumper · #2 10-05-2009, 10:24 AM

http://www.meau.com/functions/dms/ge...00000472800000
This should help.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- How to initial parameter error meldas 300 series	gunawan_tehnik	Mazak, Mitsubishi, Mazatrol	4	11-03-2010 10:11 PM
Need Help!- Meldas-300 series / MNAP L III initialize procedure	iNUC	Mazak, Mitsubishi, Mazatrol	10	04-22-2010 06:16 PM
Need Help!- MELDAS 300 series	DANMI38	Mazak, Mitsubishi, Mazatrol	2	03-09-2009 11:59 AM
How to change to Baudrate on Meldas 300 Series Controller?	Josh Lehman	Mazak, Mitsubishi, Mazatrol	1	01-16-2009 05:20 PM
meldas 50 Series	nastek	Mazak, Mitsubishi, Mazatrol	5	12-31-2006 10:32 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)