Need Help!- UNKNOWN FAULT CODE

[CNC_BOB]

hellow fellow OKK users, I got an alarm while running and can not find it in our books anywhere, it gave me PL0011 #2011 "COOLANT UNIT TROUBLED 1" I shut down and rebooted the machine the next day and so far it has run fine?? any clues are greatly appreciated because OKK would not return my phone calls

[Mitsman]

Look in your electrical manual from OKK. All PLC alarms are in there. Check the filter on your oil coolant unit. It may be getting dirty.

[CNC_BOB]

thanks mitsman , filters look good, our OKK rep says it is a phase detect circuit problem so our electrician bypassed it because we know our phasing is corect and that solved the problem untill we can find a replacement component. what type of control so you have? ours is a 635 V

[Mitsman]

For standard Mitsubishi controls we have here at least one of the following: 5000CII, M83, M84, M85, M86, M0, L0, M300, M3, L3, C3, M2, M2A, M500, M50,C5, C6, E60, E68, M60, M64, Magic64, M65, M66, M64S, M65S, M66S, M610, M625, M635, M635V, C70, M70A, M730, M750, M720BM.

[CNC_BOB]

are you saying that you have info for the 635V ? if so I would appreciate any PDF documentation, I downloaded the basic operations and programming PDF from the mits website but any "in depth" info on this machine seems hard to come by, thanks

[Namnp2007]

Dear all.
Pls. help me. I have an alarm E20 on OKK MHA300( used Meldas 84 controller) when I power on, so my machine can not start. Does any ones can help me to solved this problem.
Thanks.