- ATC trouble width mcv 300
-
Registered
-
-
Registered
Re: ATC trouble width mcv 300
My machine is stuck on toolchange with arm at 75 degrees and with toolcup in magazine pos. Prior to it getting stuck i recived a ATC alarm from a m06
You mean after finishing a tool, program goes to M06, at this time one tool is still in spindle while the other is stuck on the way comes back to magazine and slightly tilted.
In case of OKK 550 machine: Reset > M102 > Input __ Tool comes back to POT
Handle Mode > move down Z > Z Zero Return, Finish
I do not know ab how your machine is, try it.
Good luck.
Could you please show me how to Upload pic.? It is useful for me later, Thanks.
- ATC trouble width mcv 300
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules