Problem One shot oiler failed - NM200

Results 1 to 5 of 5

Thread: One shot oiler failed - NM200

  1. #1
    Member
    Join Date
    Dec 2009
    Location
    USA
    Posts
    594
    Downloads
    0
    Uploads
    0

    Question One shot oiler failed - NM200

    After 7+ years of service a plastic part on the bottom of my Fheng one shot oiler failed. I am assuming that a replacement part is not in the cards and that I'll need to replace the entire oiler.

    I've seen this one that looks almost identical. https://www.kbctools.com/products/FL...OIRS/3287.aspx

    What are the Torus machines being supplied with?

    Similar Threads:


  2. #2
    Member
    Join Date
    Jun 2013
    Location
    USA
    Posts
    1041
    Downloads
    0
    Uploads
    0

    Default Re: One shot oiler failed - NM200

    Could you make the part of you had access to a handy dandy cnc mill? 😉

    Ben

    Sent from my HTC6525LVW using Tapatalk



  3. #3
    Member
    Join Date
    Aug 2007
    Location
    usa
    Posts
    359
    Downloads
    0
    Uploads
    0

    Default Re: One shot oiler failed - NM200

    It's been a few years, but mine came with the push style pump. I'm pretty sure they still come with the same style.

    https://www.kbctools.com/default.asp...48&parent=7225

    Don't have to be too bright to be me :)
    bluehandsvideo on youtube


  4. #4
    Member
    Join Date
    Dec 2009
    Location
    USA
    Posts
    594
    Downloads
    0
    Uploads
    0

    Default Re: One shot oiler failed - NM200

    John has one in stock that I will have shipped on Monday, hopefully. More expensive than KBC but known to be a bolt on replacement for the old one.

    The part that broke is a plastic piece that screws onto the bottom of the metal body. Two ears support a roll pin on which the lever rotates. One of the ears snapped off. It would certainly be possible to make a replacement in aluminum if it were worth my time and if the mill were to remain lubricated during the machining.



  5. #5
    Member
    Join Date
    Dec 2009
    Location
    USA
    Posts
    594
    Downloads
    0
    Uploads
    0

    Default Re: One shot oiler failed - NM200

    Got the new oiler today. Looks identical to the old but one of the 4 mounting holes doesn't quite line up. I wonder if they drilled out one of the tabs on the old one. Seems three screws are enough to keep it attached. I needed to swap the brass elbows with the old pump as the threads are different. Looks like 1/8 NPT on the new and 1/16 on the old. Filled it up and seems I'm back in action tomorrow.



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  


About CNCzone.com

    We are the largest and most active discussion forum for manufacturing industry. The site is 100% free to join and use, so join today!

Follow us on


Our Brands

One shot oiler failed - NM200

One shot oiler failed - NM200