I would have posted this in my old thread but its closed so here we go. We ported the Ready Motion Boards over to GRBL 0.9j using a MEGA 2560. The system still has
- 8 Axis
- 32 Outputs
- Isolated Digital Limit Switches
- Use of mechanical buttons (if using our interface)
- Easy PWM access
- Clean wire design
If your looking for a clean look and more power from your GRBL CNC look no further this GRBL shield is for you! Goto www.readymotioncontrol.com for more info and pics!
Here is a image of the Ready Motion Installed Running GRBL 0.9j mod.
We have 6 AXIS hooked up and 1 output of 8 to control a 2 hp motor controller. Pictured also is a fuse box and 24 volt and 5 volt power supplies below.
Interface Features:
- Axis locations
- Multiple users can log in to see whats running
- Jog Buttons for all axis with feed rates and distance control
- Program editor with syntax highlighting
- 6 programmable macros that save with your program
- Real time program status for error debugging and status
- Real time line number status
- Pause and Resume
- Reset Button
- Enable mechanical buttons to control everything on the user interface
- Offline G- Code visualizer
- Advanced mode to easily change system settings like
- Stepper Motor Resolution
- Stepper Drives Pule Control
- Max Feed Rate
- Max Travel
- Stepper Motor Acceleration
- Invert Step Signal
- Invert Direction Signal
- Stepper Idle Delay
- Enable Soft Limits
- Enable Hard Limits
- Invert Limit Signal
- Enable Homing
- Switch Homing Direction
- Homing Feed Rate
- Homing Limit Debounce
- Homing Pull Off Distance
- Output Toggle Switches
- Default G Code Coolant, Spindle, Laser Buttons
IMAGES
Goto www.readymotioncontrol.com for more info and pics!
Similar Threads:
- READY MOTION CONTROL | 8 Axis, 35 High AMP Outputs, Limit Switches, CNC Controller
- Newbie- VCarve Pro compatibility with Arduino/Grbl Control Software
- Need Help!- Ready to buy new motion controller
- Need Help!- Interfacing Arduino + GRBL with 3020 control box
- SHERLINE MILL CNC READY USB CNC MOTION CONTROLLER SOFTWARE