| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| NCPlot G-Code editor / backplotter Discuss NCPlot software here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
08-05-2011, 05:17 AM
| |||
| |||
Hi Scott, Ref the new feature of word address on the pointer. We have ours set to display T# H# D#. If tool 1 uses offset, then the address will show T1 H1 D1. If next tool (say 2) doesn't, the address will show T2 H2 D1. I assume the D value will only be updated when it is called again, but can you please look at cancelling at say tool change? That way if comp is not called on the following tool, a D0 is displayed instead. Thanks  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| G66 Cancel?? | TURNER | Fanuc | 1 | 02-04-2011 10:50 PM |
| How do I cancel a G92 on the fly? | Apollopeon | Fanuc | 8 | 11-05-2009 12:45 AM |
| How do I cancel a G92 on the fly? | Apollopeon | G-Code Programing | 6 | 10-31-2009 03:28 PM |
| Effect of T0 (tool offset cancel) | HuFlungDung | CamSoft Products | 5 | 09-01-2006 03:58 PM |
| tool offset cancel problem | zoeper | Machine Problems, Solutions , Wireless DNC, serial port | 8 | 04-25-2006 10:46 AM |
| | |
Linear Mode
