| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| NCPlot G-Code editor / backplotter Discuss NCPlot software here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
11-03-2010, 05:10 PM
| |||
| |||
Hi, I have been messing around with the trial version of NCPot v2.21. I am trying to get the program below to run. I copied it out of a Haas manual so I am thinking it should be right. Does NCPlot recognize G150. Or, is there something I need to configure. Thanks % O1234 T1 M06 (Tool #1 is a 0.500” diameter endmill) G90 G54 G00 X0. Y1.5 (XY Start Point) S2000 M03 G43 H01 Z0.1 M08 G01 Z0.1 M08 G150 P1002 Z-0.5 Q0.25 R0.01 J0.3 K0.01 G41 D01 F10. G40 G01 X0. Y1.5 G00 Z1. M09 G53 G49 Y0. Z0. M30 N1002 G01 Y2. (1) X-2.5 (2) Y-2.5 (3) X2.5 (4) Y2.5 (5) X0. (6) (Close Pocket Loop) M99 (Return to Main Program) %  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| G150 help | GITRDUN | Haas Mills | 1 | 09-16-2009 03:02 PM |
| Rotate a G150 pocket cycle | JWK42 | Haas Mills | 2 | 11-26-2007 10:36 AM |
| G150 question | Zeekh | G-Code Programing | 2 | 01-06-2007 10:27 PM |
| NCPlot User Defined G-codes | TURNER | NCPlot G-Code editor / backplotter | 0 | 11-28-2006 06:27 AM |
| G150 | DavidJSwanson | Haas Mills | 3 | 03-22-2006 01:09 PM |
| | |
Linear Mode
