It's been a while since I asked for any help, but I recently started getting requests for Telecaster parts to be hand engraved. I like to design these parts using a cad file as a starting point, and therefore would like to get the control plate drawing, and the scratchplate, as well as as same for Stratocasters. Also the rear cover for the Strat over the vibrato. I could take my guitars apart and digitize them, but if someone already has done this, it would save a bit of trouble. Thanks.
Also would anyone want to cnc cut the parts out steel, or aluminum for the telecaster parts and strat scratchplates and rear covers?
Mark in Nashville, TN
Last edited by mgdesigns; 11-09-2008 at 10:34 PM.
I make most of these parts. Contact me to discuss...