I have a question regarding what may or may not be a real issue however it is a bit confusing to me. I have been doing my drawings in Rhino5 with tool paths being done with Rhinocam 2015. I just received my Laguna IQ HHC. I noticed that on the HHC the fle extension was .mmg so I called the support, they assured me that the unit could read either extension as long as I converted to metric. The tech was not specifically versed in Rhino and stated that just adding g21 to the top of the gcode file would convert as necessary. I am not confident enough n the conversation to just crank it up. so I though I would ask here for some insight and or direction I am itching to cut some wood. any help would be greatly appreciated.

FYI I have no CNC experience but am fairly technical I am a hands on luthier adding technology to my guitar shop

Similar Threads: