hi everybody
maybe somebody from cnc teknix in australia can chime in.
i have a multitek controller (cnc teknix) with tek10 servos and the deskcnc software connected to one of my mills.but with a high encoder count (got 40641 signals per inch) and low voltage (got only 52vdc) the machine operates only at a very low rapid. (runs good)
so i checked the manual about an encoder devider switch and voila there it was.changed it, and got now reasonable feed/rapids.
but what i also got was that the machine is now losing positions and i am not talking 1 to 2 thou.
30 thou at a countour with maybe 25 arc movements
if the majority of the travel is in x, the biggest loss is in x direction.
i set it back to no-devider mode but would still like to know what went wrong
thanks
hans

Similar Threads: