Setting Multicam MG X Axis

[coachbroesch]

Hope someone can help........my machine fails the X axis during the homing process. I have tried to reset.....but need some tips. I know that I need to get calibration lights to go off at the same time, just cannot get it done.

[MCPservice]

Have you tried to square up the gantry yet.

[coachbroesch]

Hello Chris,

I can home the machine with the bolts loose, as soon I go through the process of tightning the blots, it will not home the x axis. I loosen the blots and it will home again. Uhmmm? Any suggestions?

[coachbroesch]

Hello Chris,

I can home the machine with the bolts loose, as soon I go through the process of tightning the blots, it will not home the x axis. I loosen the blots and it will home again. Uhmmm? Any suggestions?

[MCPservice]

it sounds like your targets are off....do me a favor and take a picture of the side of your machine, where your racks are at the front for the machine.