Programming Question

[DJ605]

I recently purchased an older Multicam model 6614SF. It's about 14 years old and am using Enroute 4.0 write my programs. The CPU runs on Windows XP and communicates with the machine using MX32 communication software. I have the machine and CPU communicating well after hours of trial and error. My problem now is every program I write chooses tool position #1 no matter what tool I program. I have 6 holders and no matter what it chooses tool #1. Anyone have any insight on this? I'm lost.

[MCPservice]

Did you tell Enroute that you have a tool changer, and what position your tools are in?