Results 1 to 1 of 1

Thread: Rout not handling arcs and splines well

  1. 10-05-2011, 10:21 AM #1
    jbcourt
    jbcourt is offline
    Registered
    Join Date
    Oct 2009
    Location
    usa
    Posts
    21
    Downloads
    0
    Uploads
    0

    Rout not handling arcs and splines well

    I have a part made up of spline data and a few arcs. The multicam router wants to cut two large arcs where the rads are on the part. SEE PIX

    I have changed the post to push out I and J codes and also R codes. None seem to make a diffrence.

    Any ideas?
    Attached Thumbnails Attached Thumbnails Rout not handling arcs and splines well-help_001.jpg   Rout not handling arcs and splines well-help_002.jpg   Rout not handling arcs and splines well-help_003.jpg  

« nead halp multicam 3000 | Reference Bit ??s' »

Similar Threads

  1. Converting splines to arcs
    By bennett71 in forum Autodesk Software (Autocad, Inventor etc)
    Replies: 6
    Last Post: 10-26-2011, 06:10 PM
  2. Need Help!- Incremental arcs and Break arcs into lines
    By forhire in forum NCPlot G-Code editor / backplotter
    Replies: 10
    Last Post: 09-16-2010, 11:55 AM
  3. Can you rout 3D on a 2 1/2d Machine (slicing)?
    By karbunkle1952 in forum General CAM Discussion
    Replies: 9
    Last Post: 04-12-2007, 07:50 PM
  4. 'What type of aluminium to buy to cnc rout out?
    By Apples in forum General Metalwork Discussion
    Replies: 3
    Last Post: 09-27-2006, 05:20 PM
  5. Proper handling of arcs?
    By Joe Petro in forum TurboCNC
    Replies: 4
    Last Post: 03-22-2006, 11:17 AM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Recommended Links

Quick Links

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.