mori seiki sl-25 overtravel

[drlx3]

Hey I recently purchased some late 80's sl-25 lathes. I have over-traveled x axis and can not figure out how to release. I have several mazaks, but these are so different than mazatrol. Thanks in advance!
David

[underthetire]

Press the overtravel release button (next to comm port), while holding it down, press control on button, select handwheel mode and back off limit.

[tommynazareth]

You have to press 'emergency release' + 'reset' + 'power on' while jogging away from limit switch.

You'll probably need two people.

[camaru]

I have a mazak qt10 lathe with the t1 control. when I start the machine and home it, it homes flawlessly. After homing the machine I try to move off home Z- it instantly alarms overtravel Z- 046 alarm. thanks for your help in advance.

[fordav11]

this forum is for Mori lathes which are Fanuc based. Post your question in the Mazak forum.....
Mazak, Mitsubishi, Mazatrol - CNCzone.com-The Largest Machinist Community on the net!