Solidcam Post - CNCzone.com-The Largest Machinist Community on the net!

Pinball · #1 11-05-2009, 04:23 PM

Hello all, can anyone help i have just got my hands on a Mori Seiki Dura Vertical 5100 and am looking for a 'Post' that will work on Solidacam r12 2008
Any help greatfully received.

underthetire · #2 11-05-2009, 05:05 PM

You know that control can convert DXF files right? I know, not the same. Should be same post on any Mori vert. mill from the current line up back to the MSC series controls. They only added a few extra Mcodes for chip conveyor etc...

Pinball · #3 11-06-2009, 07:45 AM

Thanks, I didnt know that you could use other posts so i will into that now. Once again thanks for the help

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Post Processor for SolidCAM and Mach3	skipper	Post Processor Files	10	01-09-2012 09:04 AM
Need Help!- Help,I need a solidcam 2008 post for Maho	southpool	SolidCam	2	01-03-2012 09:19 AM
New Machine Build- Does anyone have a Post for Solidcam and Prototrak	190773	SolidCam	4	02-25-2009 01:19 PM
Problem- Solidcam Post	Pinball	Haas Mills	2	11-04-2008 04:23 PM
SolidCAM post processor	psyko2099	Post Processor Files	0	09-06-2007 02:03 AM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)