Mori MV-JR Power down during ATC error - Please help!

[dddamian]

Hi all,

Similar to mshopsteve's post I have a MV-JR stuck in the midst of an ATC tool change during power down, so the machine just boots to that error (#35).

Until I can get this figured out, can anyone help me bypass this? Can I jumper something, or are there some M-codes to reset it? I really need to get this machine running now, and can afford to go back and fix things properly at a later date. Even doing manual tool changes right now would let me get some jobs out the door, if only I could get past this alarm.

Please help if you can!

Best Regards,

Damian

[underthetire]

Check other post For MVjr. It is not something you can bypass. Well you can, but its really not to hard to fix the problem. Try that first.

[lmostafa]

[QUOTE=dddamian;668130]Hi all,

Similar to mshopsteve's post I have a MV-JR stuck in the midst of an ATC tool change during power down, so the machine just boots to that error (#35).

Until I can get this figured out, can anyone help me bypass this? Can I jumper something, or are there some M-codes to reset it? I really need to get this machine running now, and can afford to go back and fix things properly at a later date. Even doing manual tool changes right now would let me get some jobs out the door, if only I could get past this alarm.

Please help if you can!

Best Regards,



mek machie to MDI "M31;"inset M35;insert START, sty pushing "+X"
after go to keepl K8.0 mek it to 0
to finish "M32"
restart machine
its all

[dddamian]

Thanks lmostafa - keeprl 8 is the key. As long as it's latched in there is little you can do with the machine....

[lmostafa]

pleas in need a hand book for fanuc OM OT maintenace book;connecting book.
if you have hit send by email : lmostafa@hotmail.fr
thaks

[lmostafa]

please i need help i want have a document maitenace for fanuc OT;OM .
if a man have hit send mi by email:lmostafa@hotmail.fr