Duravertical 5080 and Nikken 6” 5AX-150DA21-FAM

[hernando]

Hello,

Does anyone have seen this combo in action? If, so could you please write your opinion/review of this particular combo.

I would appreciate any input. How do they work together? What possible problems? etc.

I am planing to use Mastercam 9.1 to program parts. But I am not familiar with post-processor. Any advise?

And one more thing could I use Mapps?

I am in an early face of planning. This set-up was formulated by the machine tool representative. Salesman out the equation. I just want to find out anything about this set-up by anyone that either, has it or it is working with it.

Thank you.

[underthetire]

Ellison had one running on a Dura at Westec. Not true 5 axis but for position/contour worked well.