MV Junior Parameters??!!?2#%!! Help Please!

[John_B]

Does anyone have an MV Junior that could send me their parameters? I have been unable to back-up these since I got the machine due to a faulty comm board (won't send - only receives), and thought I could just be careful and make it.
Over the weekend it got real cold in my shop and the back-up batteries went dead - so the machine did too...
I really would appreciate even a suspect copy that I can start working with!
Best regards,
John

[John_B]

I guess I should have mentioned that the machine has the Fanuc 10M control, and is about a 1984 year model.
Thanks!
John

[mshopsteve]

hey john, i have good news and bad news, i have the same machine,make/model and year.and will gladly help ya,-but im powered down with a znr suppresor diode blown out,on a servo drive, so lets stay in touch.by chance do you have any manuals?please let me know -i might have the needed prams save on a flash drive now that i think about it. please be patient with me for im new to the forum proticall and wash.st weather is the worst right now for getting around. thanks steve

[John_B]

Steve,
Yes I do have the manuals for the machine. Probably not all of them, as no matter how complete a set you think you have there inevitably seems to be another one from Fanuc that you have to get.
Tell me what you're looking for and I'll get it to you offline.

Thanks & best regards,
John

[mluqman]

Maybe this site could be useful for another Fanuc FAQ http://cnctechlearn.blogspot.com thanks

[AndreasBanuhadi]

param.txt
I have only the NC parameter.
Check it out,goodluck

[John_B]

Andreas,
Is the list you posted from an MV-Junior or an MV 40? I have loaded the setttings and get several alarms that appear to be related to the larger machine.
Best regards,
John B

[AndreasBanuhadi]

Hi John,
That is from MV junior Old series with Fanuc 10M,BT40 s/n 1833,as we know,MV Junior has many type and generation,the youngest use Fanuc 0M.I think you just need to set the servo parameter.
Good luck.
Regards,


Andreas

[John_B]

Back online. Thanks for the help guys!
Best regards, John

[dnunes]

looking for the manuals for mv jr w/ funuc m10? Im getting an alarm code OT001 Z Overtravel and OT108 Votage (24V) Too High

Can anyone help me Please?

Nunesdm98@yahoo.com or 5592812462

Thanks Doug