Please, help me:(

[damcyk]

I hit in measure sensor(to measure tools) by drill on rapid feed(approach) because I introduce bad length(to short) of tool. Operator said that sensor show bad length about 0.8 mm. in Z axis. That machine is Mori Seiki NH 4000. I don't know if I damage sensor. Mayby it's has some safety lock? If sombody could help me I will be graceful. Sorry for my language:/

[JH-Q]

Just measure all the tools again, then they all will have the same Z position. If the tool eye is not repeating (different measurements at each time), then you might have some problems.

[damcyk]

Originally Posted by JH-Q Just measure all the tools again, then they all will have the same Z position. If the tool eye is not repeating (different measurements at each time), then you might have some problems.

Thanks for reply but service will visit us tomorrow and we will see what's wrong.