NV5000 & Angle Heads ?

[KKM]

I am trying to find out if the NV5000 can handle #12 angle heads. Can the swing arm be slowed down for just the heavy head or what else can be done. I will be running two angle heads in the program. Fifteen min cycle time. I need this to have reliable tool changes for the long term , year after year.
Kevin

[underthetire]

Yes, specify large tool in the tool set up page. Even 12# at high speed should be fine, but you should specify large tool to keep tools away on either side of the angle head when it gets put in the magazine.