Need Help! Mori seiki zl 45 cnc lathe machine (Double Turret) - CNCzone.com-The Largest Machinist Community on the net!

Asfar · #1 01-21-2012, 03:57 AM

I have found 911 ram party (high) message. I think i need to clear the memory and upload again but i dont have any parameter list in my machine. so how can i get?

underthetire · #2 01-21-2012, 10:53 AM

Yes, you will need to re initialize the control. Mori might be able to provide the parameters, but I will guarantee it will take them a while to get it. If it comes up with the same alarm after initializing it, you will need replacement parts.

fordav11 · #3 01-21-2012, 10:53 PM

oh and to the OP, please don't cross post the same issue in multiple posts.
Please try to keep all of your questions relating to the same problem in the same thread to avoid duplication.

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Mori seiki zl 45 cnc lathe machine	Asfar	Mori lathes	0	01-14-2012 05:15 AM
Need Help!- Mori Seiki DL-150 Turret ref.	rai	Mori lathes	2	07-12-2011 04:10 AM
Problem- HITACH SEIKI MODEL 25D DOUBLE TURRET MACHINE, ONLY DATA TABLE PARAMETER NEEDED	rajesh_1355	Fanuc	0	04-16-2011 01:17 PM
Mori Seiki SL3 lathe	peckw	CNCzone Club House	5	08-24-2010 01:44 AM
Mori Seiki SL 0H turret	tapserv	Mori lathes	4	01-20-2008 01:01 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)