Problem parameter trouble - CNCzone.com-The Largest Machinist Community on the net!

drlx3 · #1 10-11-2011, 08:35 AM

I've got a SL-25 with fanuc 10T control, machines were bought used and we have had them for a while just sitting in storage. Now that we are trying to get them powered up both come up with RAM PARITY ERROR and I can't proceed. Thanks for the help in advance!

fordav11 · #2 10-11-2011, 04:24 PM

you need to clear the memory. with power off hold RESET and DEL keys then power on. your control may require different keys but it will achieve the same result. all memory cleared.

ROBBY 68 · #3 10-23-2011, 12:18 AM

You have to have parameter list to load after performing procedure mentioned
Robby

Thread Tools	Search this Thread
Show Printable Version Email this Page	Search this Thread: Advanced Search
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need Help!- Trouble with V24	robrea	BobCad-Cam	17	05-14-2011 04:49 PM
Trouble	extreme	DIY-CNC Router Table Machines	36	07-11-2010 04:14 PM
THC trouble?	Red Earth	DynaCNC	5	07-01-2007 09:04 AM
100 in/min X, Y, Z with IH CNC Kit. Any Trouble??	haysys	Industrial Hobbies (Support forum)	10	02-01-2007 08:24 PM
Am i asking for trouble?	phantomcow2	DIY-CNC Router Table Machines	16	01-02-2006 06:35 PM

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)