Need Help!- Yasnac programming set/up

[Mark and Poco]

I am working on a mori sl-2 with a yasnac 200g single line controller. I have a bunch of old programs that are still used, but the person who knew how to set-up the machines has left the company. My question is with the following program if i can get a walk thru for setting tool offsets I would appericiate it.

Set up sheet info:
X dia. setting 60000
Z setting 61250

T2 x-60000
z 15000

tool stick out 2.6250

now the program (tool is a spot drill)
N2 G50X-60000Z15000S1000
G00T0202
G97S110M3
G0X0Z1000M08
Z100
G1Z-200F30
G00Z10000
X-60000Z15000
T0200
M30

N1000G00T0816
M30

Just to get the machine running I have been using the x,z "offset" position in the g50 block, and the g00 return block, apparently it was done differently with machine lock in the past. Just trying to figure it out. Any help would be appericiated.

Mark

[Slick27]

Give me a call it is easier.

413-329-1503
Mark Reuss

[Mark and Poco]

Thanks I'll give you a call later today.