My turn for help. SLXXXSMC

[underthetire]

I got conned in to putting a barfeed on a SL150SMC this week. It's been years since i did one, any one have the skip (end of bar) call for the main program and the top cut program? A generic MORI one is fine, just need to check signals.

Thanks

[tminnig]

Honestly, I'm not sure if this is what you are looking for, but you've been helpful to me so I thought I'd attempt to help you out in return...

On all of the SL's and NT's that I run using barfeeders, the machine technicians wired in a second block delete function (at least I think they had to wire it in to the panel), so the call from the main program looks like this:

/2 M98 P1234;

/2 is the secondary block delete that is activated at the end of the bar,and Program 1234 is obviously the subprogram that controls the turret clearances and the top-cut program for the new bar.

Maybe this helps?

Travis

[underthetire]

I think that will work. Thank you. I forgot about the second block delete.