| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Mori lathes Discuss Mori lathes here. |
| | |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-24-2010, 01:41 AM
| |||
| |||
turret spins indefinitely. Replaced 2 bad prox switches. #1 index & turret clamp. From tool #1 home position, with home light on, switch set to #2 thru #8, turret will index to just before #3 position, hesitates, then rotates slightly, then seats... Will not index after (error). Will not home after reset. Book suggests gain adjustment. Home, turret clamp & count signals good at Control DGN's. Any/all ideas considered. Mori tech suggested that the turret contactor goes bad on this machine. Causing the turret deccel signal to fail. Which is the turret contactor? Does the turret clamp prox. switch have any effect on the indexing, or just clamp/unclamp?  |
|
#2
12-24-2010, 02:04 AM
| |||
| |||
| Please check the encoder of the turret motor, it appears to be malfunctioning. Thanks |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Home made lathe turret | brucesu1 | Mechanical Calculations/Engineering Design | 4 | 09-22-2009 12:20 AM |
| Help SL-20 turret will no home | CNCMAN 83 | Haas Lathes | 2 | 03-09-2009 05:27 PM |
| fanuc 21i double turret | nabil_elbadri | Fanuc | 2 | 01-11-2008 11:08 PM |
| Turret won't home upon startup, pls help | Millenium | Haas Lathes | 5 | 07-21-2007 09:19 AM |
| Fanuc 18i - KIA SKT250MS - Turret ? | Joey | Fanuc | 20 | 02-27-2007 10:23 AM |
| | |
Linear Mode
