Results 1 to 3 of 3

Thread: Hittachi Seiki NR III with Seicos A10L Hard Drive

  1. #1
    Registered andra's Avatar
    Join Date
    Oct 2007
    Location
    Malaysia
    Posts
    18
    Downloads
    0
    Uploads
    0

    Hittachi Seiki NR III with Seicos A10L Hard Drive

    I have hitachi seiki NRIII with Seicos lambda 10 L, this problem can't start up now, after check i found the hardrive fail ( i try to change with other hardrive with same machine., and this machine can run ). I try to read This Hard drive using PC but unlucky, in Bios This HD can Detect, but on windows ( under disk management ) say...Unlocated . This machine using NEC PC-9800 with MS Dos 6.20, i also try to open this harddrive using DOS 6.20 but ..same can not read.
    What tool can i using to read this hard drive? please help me , thank you..


  2. #2
    Registered andra's Avatar
    Join Date
    Oct 2007
    Location
    Malaysia
    Posts
    18
    Downloads
    0
    Uploads
    0

    Smile Problem solved

    Dear all,
    my problem has solved, i try to clone this OK harddrive using freeware from internet. thank all.


  3. #3
    Registered
    Join Date
    Sep 2012
    Location
    France
    Posts
    1
    Downloads
    0
    Uploads
    0

    PB ON HITACHI SEIKI SEICOS A10L HARD DRIVE

    HELLO , I HAVE SEEN ON THIS FORUM THAT YOU ACHIEVE TO MAKE A COPY OF YOUR HARD DRIVE WHICH SOFTWARE ARE YOU USING , CAN YOU HELP ME


Similar Threads

  1. Hitachi Seiki Seicos
    By Enda in forum Fanuc
    Replies: 6
    Last Post: 12-15-2009, 12:14 PM
  2. hitachi Seiki VK45 with Seicos II
    By Dancy in forum General CNC (Mill and Lathe) Control Software (NC)
    Replies: 7
    Last Post: 12-13-2007, 03:26 PM
  3. hitachi Seiki VK45 with Seicos II
    By Dancy in forum General Metal Working Machines
    Replies: 4
    Last Post: 12-11-2007, 03:16 PM
  4. Hitachi Seiki Seicos Sigma
    By Enda in forum Fanuc
    Replies: 0
    Last Post: 04-18-2006, 04:49 AM
  5. Hitachi Seiki Seicos Sigma 21L
    By Enda in forum General CNC (Mill and Lathe) Control Software (NC)
    Replies: 0
    Last Post: 02-21-2006, 04:22 PM

Posting Permissions


 


About CNCzone.com

    We are the largest and most active discussion forum from DIY CNC Machines to the Cad/Cam software to run them. The site is 100% free to join and use, so join today!

Follow us on

Facebook Dribbble RSS Feed


Search Engine Friendly URLs by vBSEO ©2011, Crawlability, Inc.