- Mori Seiki TV-30 MSC-802M (M50) interpolation problems
-
Registered
That is NON-OP mode. The E-stop is in, or the air pressure is low. One of my machines has the air pressure alarm and the other does not, or it was bypasses by the previous owner. Check those two things out and if you are still stuck, let me know.
Jim
-
-
Registered
Doh!
E-STOP was in because I had pressed it. LOL
-
Registered
HA HA, yeah, sometimes that happens!
-
Registered
-
Registered
How to restore mitsubishi MSC 802M mori seiki tv30
-
Member
Re: Mori Seiki TV-400 with MSC-802M (M50) Manuals required
Dear All
Request You to kindly help me.
I am working with Mori Seiki TV-400 with MSC-50M control for my friend.
Need Operation manuals for read & run machine.
if possible kindly share APC operation manual also.
His mail ID :- cncmainte@gmail.com
thanks
Last edited by ajayoip; 10-09-2015 at 04:21 AM.
-
Member
Re: Mori Seiki TV-30 MSC-802M (M50) interpolation problems
hi all
i have machine TV30 with MSC-802. all good but all axis going in positive direction. when i move in -ve the error. M01 operation error 0007.
any one can help me here?
what is the procedure of absolute zero setting?
thanks all
-
Registered
Re: Mori Seiki TV-30 MSC-802M (M50) interpolation problems
Hi Moghal,
Piece of cake.
My email is chrisclub@gmail.com
X zero is far left, Y zero is far front.
You can maximize your X and Y travel if you put it there manually with the power off before zeroing.
Turn off power, take off the front cover and the back cover
Push the table to the far left, but just before the X limit switch wheel is depressed.
Move the Y to the far front but just before the limit switch is depressed.
You will need a flashlight to see the Y limit switch wheel before it gets depressed.
Then it is simple... turn on the power,
Turn off the GOP keys,
Press DGN/IN Out, ABS-SRV, Menu, Down arrow once. The [ABS Position Set] screen should be displayed.
Type "1" in the X and Y positions.
#(0) ( 1) (1 ) ( ) ( ), Input " Origin Set" is displayed
#(1) (1 ) (1 ) ( ) ( ), Input "ORIG-RTN" is displayed
Change the scale to x10, X axis, Handle mode, and rotate the jog wheel CCW until "OK" is displayed for X
(You may have to hold in the Yellow Over Travel button behind the door on the right side of the control panel while jogging.)
Then jog the Y axis until it says "OK".
Zeroing Z is a little trickier. Send me an email if Z is also "NG".
After power cycle, it should come up fine.
But the problem is probably you need to change the 4 batteries in your Battery box in the back.
Chris
Last edited by chrisclub; 03-19-2017 at 12:29 AM.
-
Registered
Re: Mori Seiki TV-30 MSC-802M (M50) interpolation problems
Dear Sir,
Could u post me or PM Macro program for ATC and APC (9001,9002 and 9003)
Many thanks in advance and best regards..
- Mori Seiki TV-30 MSC-802M (M50) interpolation problems
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules