Mori w/Yasnac LX3 has reversed x axis

[hammerdown]

I have an SL15 Mori with Yasnac LX3 control and the x axis has the minus on the the top of the stroke and plus on the bottom. This is the reverse of most other machines and makes programing a problem for us. I have a friend that has 3 Mori's just like ours and the X axis are in the normal configuration (plus at top minus at bottom). I need help with finding the parameters to change this machine to be the same as our other turning center or a post processor file for Mastercam that uses this reversed x axis. We can add minus signs to the program but the G2 and G3s are also reversed. Big pain in the rear.

Similar Threads:

• Mori Seiki SL2 With YASNAC
• Need Help!- Drip Feeding Mori Seiki MV-40B X axis reversed?
• Mori Yasnac LX1 X axis inverted
• MORI MV-65 / MORIC-3Y ( Yasnac-MX3)
• Mori Jr with Yasnac MX2, a little help

[jaherrera3499]

1. CHANGE THE FOLLOWING PARAMETERS:

A. 6010.6 1
B. 6600 12000
6606 -262000
C. PC PRM 7000.7 0



2. CHECK THE CN2 CONNECTOR ON THE X AXIS MOTOR, MAKE SURE THAT FOLLOWING PINS ARE NOT SHORTED
PINS 1, 2, 3, AND 7

Hope this helps!

[chickendinner]

Just program/draw the Part in the opposing quadrant in software. Then use a turret in the opposite quadrant in post. Lower turret instead of upper... and it will post the program you want without any needed changes. It does X- instead of X+ and the G02, G03 moves should be correct as well.