acquired and SL25B with i80 control - can't figure out how to 1) tell the machine if I am holding on ID or OD chucking, 2) When I put the tool setter arm down, it takes me the offset page but I cannot move the axis at all to be able to touch off the tools. I have no books with it - any ideas? I am sure its right in front of me but i just cant seem to get it to go
Should be a aux/custom button on the control, it's a software switch usually. Not sure exactly on yasnac controls, not that many.
Tool setter , should be a PSM button on the operator panel. Turn that on and it should jog.