Where to find Machinable(CNC) Wax for molding ?

[Calico]

thanks again for the formula,
let me find the material on the list here... it's very hard to find it because of the standard here is different than in USA.
they mostly don't understand the name either.
I don;t think the clay will be available here. I have to import it from usa.
this is the problem I use to have.

let me see what I can do.
regards
ruddy

[DAB_Design]

I believe the wax that MSC carries could be melted down and applied.

If not, what about fiberglass? I'm not sure it would be too good to breath around a machine cutting it, but I think a few layers would work.

[Calico]

DAB,
yes I agree with fiberglass or epoxy will work, just apply layers.
now I'm experiment with other material to make it softer and thicker to apply.

the problem is I can not aplly it at once with 1 cm thick.
all I need is 1 cmm thick that can be apply to any surface/angled.
i still have a problem w that.

rud