| |
| Home Page | Mark Forums Read | Today's Posts | My Replies | Classifieds | Reviews | Photo Gallery | Web Links | Share Files | Advertise With Us | Ad List |
| |||||||
| Moldmaking Discuss mold making and techniques here. |
| | |
| This forum is sponsored by: |
 |
| | LinkBack | Thread Tools | Search this Thread | Display Modes |
|
#1
 
12-27-2007, 01:50 PM
| |||
| |||
Hello, I'm making a mold out of plastic flat stock.While rastering both horizonal and vertical I get lines in the mold.They are not deep and about 1/4" apart on horizonal and 1" apart on vertical.I adjusted for backlash and it did get better in the beginning,but the more it mills the worst it gets.My mold is 2.5 x 5.375 in.It starts about half way across the mould.I don't think it's the z axis,but I could be wrong.Just need some help on this one.Thanks! Dh2000  |
|
| | |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | Search this Thread |
| Display Modes | |
| |
Similar Threads | ||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PVC Compressed Air lines | Five-10 | CNCzone Club House | 47 | 01-07-2011 07:51 AM |
| Making a positive mold from a negative mold - how? | SRT Mike | Moldmaking | 7 | 03-29-2007 04:30 PM |
| ReOrdering lines | rherman | BobCad-Cam | 0 | 12-21-2006 11:34 AM |
| PRoblem seeing dxf lines | Ed_R | SheetCam | 4 | 03-25-2006 03:32 PM |
| Can't see lines | Mr.Chips | TurboCAD/CAM | 4 | 04-03-2005 10:29 AM |
| | |
Linear Mode
